B52-10 Acrylic Finish Paint

This single component product is mainly prepared by acrylic resin,       chlorinated plasticizer,  pigments, fillers, solvent, etc. It features great properties as:

Good gloss and color retention	One coat protection	Fast air drying
Easy to apply	Great resistance to abrasion	Oil & water resistance

B52-10 Acrylic Finish Paint Video

B52-10 Acrylic Finish Paint Basic Technical Datasheet

Color	Custom color
Density, kg/L	~1.10
Flash point,℃	25
Solid  content	≥40%
Gloss (60°)	40
Hardness	≥H
Impact resistance, cm	50
Bending test,mm	2
Adhesion, MPa	≥6
Resistance to water, 24h	No blister, no peeling and slight yellowing
Resistance to gasoline, 3h	No tacky, softening and blister
Theoretical spreading rate, kg/m2 @ 50 µm dry film	0.22
VOC, g/L	420

B52-10 Acrylic Finish Paint Product Packaging Packaging: 22 kg in a 20-liter iron barrel. Shelf Life: 12 months If exceeding shelf life, the products shall be tested before using.

B52-10 Acrylic Finish Paint Applicable Environment

Ceramic handicrafts	Aluminum material	Machinery	Automobile parts and components
Exterior wall surface	Rigid plastic	Garage floor	Offshore platforms

B52-10 Acrylic Finish Paint Compatibility

	Product	Thickness
Primer:	H06- 1 Epoxy Zinc Rich Primer	2*40 µm
Midcoat:	H53-6 Epoxy Mica Iron Oxide Paint	150 µm
Topcoat:	B52-10 Acrylic Finish Paint	2*40 µm

B52-10 Acrylic Finish Paint Finished Projects

B52-10 Acrylic Finish Paint Production Process

B52-10 Acrylic Finish Paint Instructions For Use

Substrate Treatment：

All surface shall be clean, dry and free from any contaminations to achieve

long lasting function.

 Primed surfaces

Minimum surface preparation is Hand clean to St2.5. Remove all oil and grease from surface.

      Primed surfaces

The primer surface should be dry and free from all contaminations.

If paint is peeling or badly weathered, clean surface to sound substrate and treat as a new surface as above.

      Concrete and masonry

Surfaces should be thoroughly cleaned and dry.

Instructions for Use:

Thinner:

X- 16 acrylic paint thinner ≤ 10 % w./w.

   Cleaner:

X- 16 acrylic paint thinner

Application methods:

Airless spray (recommended)：  Nozzle tip: 0.017-0.023 inch, minimum 150 bar/2100 psi.

Brush: recommended for small areas only.

Roller: recommended for small areas only.

B52-10 Acrylic Finish Paint Company Introduction

B52-10 Acrylic Finish Paint Exhibitions