Chlorinated Polyether Anti-corrosive Paint

This product is a high performance anti-corrosive product containing chlorinated polyether resin, composite modified resin, anti-rust pigments and fillers.It has the following characteristics：

Fast drying	Strong adhesion	Weather resistance
Salt spray resistance	Seawater corrosion resistance	Good appearance and gloss

Chlorinated Polyether Anti-corrosive Paint Basic Technical Datasheet

Color	Customized
Gloss	Semi-gloss
Density	~1.3Kg/L(after mixing)
Solid Volume	(45±2 )%
Standard Film thickness	60um dry film thickness  (about 135um wet film thickness)
Theoretical spreading rate	5.77m²/Kg (60um dry film thickness)
Flash Point	27℃

Chlorinated Polyether Anti-corrosive Paint Product Packaging Packaging: part A：20 kg in a 20-liter iron bucket. part B：4 kg in a 5-liter iron bucket. Shelf Life: 12 months If exceeding shelf life, the products shall be tested before using.

Chlorinated Polyether Anti-corrosive Paint Applicable Environment

Chemical pipeline	Pipe rack steel structure	Acid and alkali tank	Metallurgical plant
Storage tank exterior	Bridge steel structure	Industrial workshop	Substation

Chlorinated Polyether Anti-corrosive Paint Compatibility

	Product	Thickness
Primer:	Epoxy Anti-rust Primer	2*40 µm (dry film thickness)
Midcoat:	Epoxy Intermediate Paint	2*50 µm (dry film thickness)
Topcoat:	Chlorinated Polyether Anti-corrosive Paint	2*30um (dry film thickness)

Chlorinated Polyether Anti-corrosive Paint Finished Projects

Chlorinated Polyether Anti-corrosive Paint Production Process

Chlorinated Polyether Anti-corrosive Paint Instructions For Use

Substrate Treatment：

All surface to be coated shall be clean and dry. The surface shall be evaluated and treated according to ISO8504 standard.

For bare steel, it shall be sandblasted to reach Sa2.5(iso8501-1:2007) standard. Depending on the environment of the non-immersed part, grinding with power tools is acceptable but shall at least reach St2(iso8501-1:2007) standard.

For shop primed steel, the shop primer shall be clean, dry and approved.

For surface painted coatings, this product can apply only to clean, dry and good compatible primer.

Instructions for Use:

• Mixing:

Ready to use

• Mixing ratio:

Part A: Part B=20:4

• Thinner:

Exclusive thinner

• Airless spray:

Nozzle tip: 0.018~0.025 inches

Spray pressure: 18~25Mpa

Thinner ratio: 0~15% (by weight of paint)

• BrushRoller:

Recommended

Must achieve required thickness

Chlorinated Polyether Anti-corrosive Paint Company Introduction

Chlorinated Polyether Anti-corrosive Paint Exhibitions