Epoxy Chlorosulfonated Cross-linked Anti-corrosive Paint

This product is a two-component cross-linked anti-corrosive paint composed of chlorosulfonated polythene rubber, epoxy resin,  stabilizer, organic solvent, etc.It has the following resistance characteristics:

Fast Drying	Strong Adhesion	High Strength
Damp Heat Resistance	Salt Spray Resistance	Acid and Alkali Resistance

Epoxy Chlorosulfonated Cross-linked Anti-corrosive Paint Video

Epoxy Chlorosulfonated Cross-linked Anti-corrosive Paint Basic Technical Datasheet

Color	Customized
Gloss	Semi-gloss
Density	~1.25Kg/L(after mixing)
Hardness	Epoxy chlorosulfonation paint curing agent
Solid Volume	(50±2 )%
Standard Film thickness	60um dry film thickness  (about 120um wet film thickness)
Theoretical spreading rate	6.67m²/Kg (60um dry film thickness)
Flash Point	27℃

Epoxy Chlorosulfonated Cross-linked Anti-corrosive Paint Product Packaging Packaging: Part A 20kg in a 20-liter iron bucket. Part B 5kg in a 6-liter iron bucket. Shelf Life: 12 months If exceeding shelf life, the products shall be tested before using.

Epoxy Chlorosulfonated Cross-linked Anti-corrosive Paint Applicable Environment

Plant Steel Structure	Storage Tank	Piping	Container
Dock	Bridge	Steel Tower	Desulfurization Tower

Epoxy Chlorosulfonated Cross-linked Anti-corrosive Paint Compatibility

	Product	Thickness
Primer:	Epoxy Glass Flake Anti-rust Paint	2*40 µm (dry film thickness)
Topcoat:	Epoxy Chlorosulfonated Cross-linked Anti-corrosive Paint	2*30 µm (dry film thickness)

Epoxy Chlorosulfonated Cross-linked Anti-corrosive Paint Finished Projects

 

Epoxy Chlorosulfonated Cross-linked Anti-corrosive Paint Production Process

Epoxy Chlorosulfonated Cross-linked Anti-corrosive Paint Instructions For Use

Substrate Treatment：

All surfaces to be coated shall be clean and dry. The surface shall be evaluated and treated according to ISO8504 standard.

For bare steel, it shall be sandblasted to reach Sa2.5(iso8501-1:2007) standard. Depending on the environment of the non-immersed part, grinding with power tools is acceptable but shall at least reach St2(iso8501-1:2007) standard.

For shop primed steel, the shop primer shall be clean, dry and approved.

For surface painted coatings, this product can apply only to clean, dry and good compatible primer.

Instructions for Use:

• Mixing:

Use the power mixer to mix the main paint evenly, and then as you stir it, you add the hardener until you get to mix well.

• Thinner

Exclusive thinner for epoxy chlorosulfonation paint

• Airless spray

Nozzle tip: 0.017~0.023 inches

Spray pressure: 15~18Mpa

Thinner ratio: 0~10% (by weight of paint)

• Brush、Roller

Recommended

Must achieve required thickness

Epoxy Chlorosulfonated Cross-linked Anti-corrosive Paint Company Introduction

Epoxy Chlorosulfonated Cross-linked Anti-corrosive Paint Exhibitions