Polyurethane Mortar

This product is composed of water-based polyester base, curing agent,cement and aggregate mortar, and is produced through mature.It has the following characteristics：

Eco-friendly	Moisture resistance	Abrasion resistance
Impact resistance	Chemical resistance	Thermal shock resistance

Polyurethane Mortar Video

Polyurethane Mortar Basic Technical Datasheet

Color	Customized
Vicat softening point	≥140℃
Coating appearance	No cracks on the surface, uniform color
Compressive strength	≥40.0MPa
Flexural strength	≥10.0MPa
Abrasion resistance (500g/100r)	≤0.15g
Anti-slip properties (dry friction)	≥0.6
Tensile bond strength	≥2.0MPa

Polyurethane Mortar Product Packaging Packaging: 20kg/set  A: 2.5KG/barrel  B: 2.8KG/barrel  C: 14.2KG/bag  D: 0.5KG/barrel Shelf Life: 12 months If exceeding shelf life, the products shall be tested before using.

Polyurethane Mortar Applicable Environment

Food Industry	Pharmaceutical Industry	Low-temperature Cold Storage	Fine Chemical Workshop

Polyurethane Mortar Compatibility

	Product	Thickness
Primer:	Polyurethane Sealing Primer	1*30–50 μm (dry film thickness)
Topcoat:	Polyurethane Mortar	2~3 mm (dry film thickness)

Polyurethane Mortar Finished Projects

Polyurethane Mortar Production Process

Polyurethane Mortar Instructions For Use

Substrate Treatment：

An effective moisture-proof layer should be set under the concrete base where there is a potential moisture hazard, and it should comply with relevant national acceptance standards; New concrete floors must be maintained for more than 28 days; Concrete base compressive strength ≥25MPa, tensile bond strength ≥1.5MPa, moisture content ≤6%, flatness ≤3mm/2m; Use dust-free mechanical grinding or shot blasting machine to remove cement slurry, old coating, wax stains and other pollutants and impurities on the concrete surface until a suitable roughness, solid, clean, dry concrete surface or intact compatible base surface is obtained.

Instructions for Use:

• Mixing:

First, mix component A , component B , and component D in proportion , stir mechanically for 3 minutes until they are uniform , then add component C (aggregate), and stir mechanically for 3 minutes until they are uniform

• Thinner:

Do not add diluent

• Airless spray:

Base construction: Scraping - use a 2~3mm trowel for scraping ; Grinding: Grind the entire surface about 24 hours after the base material is applied (resin grinding discs are recommended) and remove dust; Surface construction: Scraping - Use a 2~3mm trowel for scraping and immediately use a defoaming roller to defoam.

• Scraping

Polyurethane Mortar Company Introduction

Polyurethane Mortar Exhibitions