Epoxy Mica Iron Oxide Intermediate Paint

The two-component high-solid product is composed of epoxy resin and polyamie curing agent.It has the following characteristics：

Excellent adhesion	Good flexibility	Impact resistance
Low‑VOC	Good abrasion‑resistance

Epoxy Mica Iron Oxide Intermediate Paint Video

Epoxy Mica Iron Oxide Intermediate Paint Basic Technical Datasheet

Color	Gray, Bronzing
Gloss	Flat
Density	~1.6Kg/L (after mixing)
Hardness	Curing agent for epoxy paint
Solid Volume	(75±2 )%
Standard Film thickness	150um dry film thickness  (about 200um wet film thickness)
Theoretical spreading rate	3.13m²/Kg (150um dry film thickness)
Full cure	(23±2℃ )7d
Flash Point	39℃

Epoxy Mica Iron Oxide Intermediate Paint Product Packaging Packaging: part A：24 kg in a 20-liter iron bucket. part B：4 kg in a 5-liter iron bucket. Shelf Life: 12 months If exceeding shelf life, the products shall be tested before using.

Epoxy Mica Iron Oxide Intermediate Paint Applicable Environment

Food Industry	Pharmaceutical Industry	Low-temperature Cold Storage	Fine Chemical Workshop

Epoxy Mica Iron Oxide Intermediate Paint Compatibility

	Product	Thickness
Primer:	Epoxy Zinc Rich Primer	1*30–50 μm (dry film thickness)
Midcoat:	Epoxy Mica Iron Oxide Intermediate Paint	2~3 mm (dry film thickness)
Topcoat:	Acrylic Polyurethane Finish	2~3 mm (dry film thickness)

Epoxy Mica Iron Oxide Intermediate Paint Finished Projects

Epoxy Mica Iron Oxide Intermediate Paint Production Process

Epoxy Mica Iron Oxide Intermediate Paint Instructions For Use

Substrate Treatment：

An effective moisture-proof layer should be set under the concrete base where there is a potential moisture hazard, and it should comply with relevant national acceptance standards; New concrete floors must be maintained for more than 28 days; Concrete base compressive strength ≥25MPa, tensile bond strength ≥1.5MPa, moisture content ≤6%, flatness ≤3mm/2m; Use dust-free mechanical grinding or shot blasting machine to remove cement slurry, old coating, wax stains and other pollutants and impurities on the concrete surface until a suitable roughness, solid, clean, dry concrete surface or intact compatible base surface is obtained.

Instructions for Use:

• Mixing:

First, mix component A , component B , and component D in proportion , stir mechanically for 3 minutes until they are uniform , then add component C (aggregate), and stir mechanically for 3 minutes until they are uniform

• Thinner:

Do not add diluent

• Airless spray:

Base construction: Scraping - use a 2~3mm trowel for scraping ; Grinding: Grind the entire surface about 24 hours after the base material is applied (resin grinding discs are recommended) and remove dust; Surface construction: Scraping - Use a 2~3mm trowel for scraping and immediately use a defoaming roller to defoam.

• Scraping

Epoxy Mica Iron Oxide Intermediate Paint Company Introduction

Epoxy Mica Iron Oxide Intermediate Paint Exhibitions